Hi I would rather NOT have to reinstall the system since it's running flawless (thank you for the excelent board) for almost 2 years non-stop. Started with OMV5, upgraded to OMV6 and currently on OMV7 (even if still in BETA stage). Just realized now, that my SWITCH can do more than it's doing and want to take advantage of it. I will do a clone of the OS and test the DEB to see what I can get from it. Do you have any pointers or tips (may some guide) on how to proceed, to create what I need: Establish a Link Aggregation on 2 to 4 ports of the Interceptor? Thank you for the support Kind Regards

Hi all Sorry for necro this but I have a need for some tips on how to use/set (at least) 2 of the ports on Link Aggregation. I run the CM4/Interceptor on OMV7 with pure RaspiOS arm64 and never got to set the other 3 ports except the WAN one. I have a TP-Link SG108E that can provide LAG on 2-4 ports and wanted to take advantage of it. If I recall correct, the ports disposition is: 2 4 1 3 Where 1 is the WAN port that is active and connected to the router. If I use that deb to install swconfig, will this cause any issues with the system as it is now? And if there's no issue, how would I configure and know which ports correspond to where they are located on the board?

@Axzez Support Maybe I didn't expressed myself properly, sorry. Since my doubts are related to the USBboot, I thought it was a good place to ask. Like I said, my CM4 is already booting from eMMC but it's impossible to edit the bootloader while connected to the Interceptor. I've tried to use a USB stick with your OS attached but the Interceptor keeps booting from eMMC and I can't seem to override it. Hence my questions. What I will try now is to mount your written OS (on the USB) on the eMMC and copy that particular file (boot.sh) to the eMMC /sbin and edit the cmdline.txt (on the eMMC /boot) to call it and see if it writes the changes to the bootloader. I'm only doing this to prevent to have to move the CM4 to a Carrier board and do it as per instructed on the Raspberry Documentation. Hope this is more clearer. Thank you for the support

Hello Maybe I'm not looking in the right place but can someone point me to where I can find references to this method? Where is /sbin/boot.sh documented? My CM4 is already booting from 32Gb eMMC and running RaspiOS Lite 64 and I can't find a way to flash the bootloader with the needed changes to use the Power On button. Of course I can always dissassemble it and put it on a Carrier Board but I wanted to prevent that. Thank you for any pointers