top of page
Forum Posts
Axzez Support
First week member
Oct 03, 2022
In Interceptor Carrier Board
We've put together a document to assist with the setup of your Interceptor System: https://www.axzez.com/Interceptor_System_Setup.pdf Let us know if you'd like to see clarification or missing information added.
0
0
53
Axzez Support
First week member
Apr 22, 2022
In Interceptor Carrier Board
Software Q. How do I monitor/reset the PoE ports? A. Use the "PoE Ports" tab of the "System Settings" utility in the Axzez provided Wayfire, 3D Wayland Compositor. Q. How do I read the PoE controller status? A. $ cat /proc/pse1/status
voltage: 47437 (40000-60000) mV
current: 40 (2500) mA
power allocated: 4000 (120000) mW Q. How do I read the PoE port status? A. $ cat /proc/pse1/port2/status
state: power on
class: 1 (4000 mW)
temperature: 43500 (150000) mdeg
voltage: 47687 mV
current: 40 (800) mA
last event: Q. How do I reset a PoE port? A. $ echo 1 > /proc/pse1/port2/reset Q. How do I set the PoE power allowance? A. This value is used to determine if there is enough power available to turn on a PoE port. If your power supply can source 120W: $ echo 120 > /proc/pse1/power_allowance Q. How do I find the IP address of the connected PoE device? A. First, get the PoE device ID (e.g. poe1-3) from the PoE Ports tab of the "System Settings" utility. Then from the command line, type the following: $ #networkctl status <device ID>
$ networkctl status poe1-3 The output will contain the IP address assigned by DHCP, if you left this default behavior enabled in the "System Settings" utility "Network" tab. Hardware Q. My Interceptor Carrier Board no longer boots or boots without USB after I connect my Interceptor PoE Board(s) and WMX Power Converter. A. Do to the power requirements of WMX Power Converter, not every PSU will work with it. Most likely, you will need a PSU with at least 550W. You can start by looking at the PSUs listed on the Interceptor Carrier Board FAQ as verified, and for that series select a PSU that offers at least 550W (one 550W PSU we tested [see list below] was not compatible, so higher is better). Here is the current list of tested PSUs. We'll keep adding to this list as we verify more: Q. How do I connect my Power Supply Unit (PSU) to the PoE Board? A. In order to do this, the PSU will require some modification. We have written this short guide to help you get setup. Note that some PSU's 4+4 pin connectors will actually be a 4+4 pin, but with 5+5 wires. One of the 5 wires will be a slightly smaller gauge than the other four and you should just group that smaller gauge wire with one of the other 4.
1
12
534
Forum Posts: Members_Page
Axzez Support
Admin
More actions
bottom of page